Page 1 of 1

Need help with Dboys M4 CQB Barrel/Suppressor

Posted: Thu Jul 18, 2013 5:41 pm
by midsummersjune
Hi guys I've been thinking about changing the entire front end of my Dboy BI-3881.

http://www.airsoftmegastore.com/755-440 ... 3881m.aspx

I need help with 2 big issues I am having and would appreciate any advice.

First of all I sadly have yet to even remove the oem mock suppressor. Any help there?

Secondly, I was thinking of getting a Madbull Gemtech G5 suppressor however once I do get the mock suppressor off there will be about 3 inches of inner barrel showing. I basically need a list of aftermarket parts (whether that be outer barrels and anything to stop it from possibly wobbling in my ris) that I can purchase and get the gemtech on in the front. I dont play cqb so I dont mind if the barrel is longer than it was before. I would actually prefer it.

As you can probably tell, I am a huge noob and this is my first gun. I'm not completely familiar with terms so please excuse any noobie things I said lol.

Re: Need help with Dboys M4 CQB Barrel/Suppressor

Posted: Thu Jul 18, 2013 6:14 pm
by Moondog
Your mock suppressor is likely hot glued onto the threads. You'll need a very hot hair dryer or similar to melt it soft and a lot of elbow grease.

You can buy barrel extenders to add put between your current barrel and the new GemTech you plan to buy which will push the Gemtech far enough that you won't get your inner barrel poking out. http://www.evike.com/product_info.php?c ... s_id=38183

Re: Need help with Dboys M4 CQB Barrel/Suppressor

Posted: Thu Jul 18, 2013 7:48 pm
by midsummersjune
Do you think 1 of those matrix barrel extensions will be enough, or can I piggy back more than one if need be?....

Re: Need help with Dboys M4 CQB Barrel/Suppressor

Posted: Fri Jul 19, 2013 9:08 am
by Moondog
If you need something longer, get a 3 piece Outer Barrel (in the M4/M16 section of their External Upgrades>Outer Barrel) which is like $35 and it can be taken down into 3 sections which can mix and match to the length you need. Since its hidden under your RIS, it shouldn't matter if the barrel setup is not 100% realistic since nobody can see it anyway.
http://www.evike.com/product_info.php?c ... s_id=38045

Your other option is to buy a slightly shorter tight bore (6.01mm) inner barrel which won't poke past your new suppressor.
http://www.evike.com/product_info.php?c ... s_id=41513